-
To delete a topographic point click Job.
-
Click Points/Measurements/Codes.
-
Open the Points tab.
Delete a single point
-
To delete a single topographic point, from the Points tab click on a point and select Delete.
A deleted point can be restored from the corresponding measurement.
Delete multiple points
-
To delete a multiple topographic point, from the Points tab click Tools and select Delete.
-
Select Delete topographic points.
-
Check the points from the list, or click Tools to use Selection rules or select/deselect all the points.
-
Click Delete to delete the points.
A deleted point can be restored from the corresponding measurement.
Delete coincident points
-
To delete points with the same coordinate, from the Points tab click Tools and select Delete.
-
Select Delete coincident points. Click YES to delete points with same coordinates.
A deleted point can be restored from the corresponding measurement.
Restore a deleted point
-
A deleted point can be restored from the corresponding measurement.
-
If a topographic point has been deleted, open the Measurements table.
-
Select the corresponding measure and click Restore.
